Pilous ARG 330 SAF Instruction Manual page 15

MAIN SWITCH
TOTAL STOP
SAW ARM END STROKE SWITCH
MANUAL MODE: position 0 - controls the arm only by the touch screen (up and down); position 1 - arm uplift
independent of the touch screen.
S.A. MODE: after the finishing cut the arm remains in the lower position - position 0, or travels to the
adjustable upper position - position 1.
Note 1: when transferring from the MANUAL to S.A. MODE (not during cutting) and by turning the switch
from 0->1 the machine will not respond, because the S.A. MODE uses the height specified in the MANUAL
MODE. In order to lift the arm, you have to edit the arm uplift height afterwards.
Note 2: when transferring from the S.A. MODE into the MANUAL MODE (not during cutting), while the
switch is in position 1, the arm will travel upwards only after you switch from 0->1 again.
EMERGENCY BUTTON
The button actuates a safety relay. When you activate the safety relay the machine will become
operational and MAIN MENU will appear on the panel.
START
Press the button in S.A. mode to start the operating cycle (clamping the material, start of the saw blade
motor and the coolant pump, arm feed towards the cut, lifting the arm into the specified position,
switching off the saw blade motor and coolant pump, vice release).
In the MANUAL MODE, the saw blade will start upon pressing the button.
SAW BLADE SPEED CONTROLLER
You can change the cutting speed using a saw blade speed controller (using a frequency converter) on the
control panel.
The display continuously shows the selected value within the range 15-90 m/min.
STOP
Press the STOP button in S.A. MODE to interrupt the operating cycle. If the END STROKE SWITCH is in
position 1, the saw blade will stop and the arm will travel upwards to the specified position.
If the END STROKE SWITCH is in position 0, the saw blade will stop and the arm will remain in the current
position.
Upon pressing the STOP button in the MANUAL MODE, the saw blade will stop.
On
Off
Use for emergency stop of the saw blade motor, coolant pump and
hydraulic unit motor (i.e. the whole machine).
You can put the machine back to operation only after you manually unlock
the switch by pulling or twisting!
Before you start the saw blade motor, always make sure that
the saw blade is not in contact with the workpiece at the
point of cutting.