Pilous ARG 330 SAF Instruction Manual page 19

ANGLE
0 9 : 2 0 : 0 3
12.1
SET
ARM LIFTING HIGH SETTING H
ARM LIFTING HIGH SETTING H
0 9 : 2 0 : 0 3
D H D H D
70 65 140 123 210
75 69 145 127 215
80 74 150 131 220
85 78 155 135 225
90 82 160 138 230
95 86 165 142 235
100 91 170 146 240
105 95 175 150 245
110 99 180 154 250
115 103 185 157 255
120 107 190 161 260
125 111 195 165 265
130 115 200 168 270
135 119 205 172 275
TIME+DATE SETTING
TIME+DATE SETTING
0 9 : 2 0 : 0 3
H M
0 0
DD MM
0 0
ANGLE
SET
SET
H D H
176 280 225
179 285 228
183 290 232
186 295 235
190 300 238
194 305 242
197 310 245
201 315 249
204 320 252
208 325 255
211 330 258
215
218
221
S
TIME
0
INPUT
YYYY
DATE
0
INPUT
Setting the cutting angle sensor - calibration
0 8 / 1 0 / 2 0 1 6
Using a framing square, align the orthogonality (90°) of the belt
against the fixed vice jaws and press the middle SET button.
Turn the saw arm to the stop on the right (60°) and press the right
SET button.
Turn the saw arm to the stop on the left and press the left SET
button.
Recommendation: Using the space between the ends of the
calibrated framing square and measuring the angle between the
saw blade and the fixed jaw.
ESC
ARM LIFTING HIGH SETTING H
0 8 / 1 0 / 2 0 1 6
Set or currently displayed arm height (H) is measured at the fixed
jaw. When cutting a log, it is possible to set a lower arm uplift
according to the table and thus the arm does not need to ascend
unnecessarily high.
Example: pipe/log in diameter 320 mm. According to the table,
set the height of the arm uplift only to 252 mm. You save the
cutting time significantly.
ESC
Input the current time in dark grey boxes in the red-outlined box.
0 8 / 1 0 / 2 0 1 6
After you input the time, press the TIME INPUT button to enter the
set time into the system.
Input the current date in dark grey boxes in the red-outlined box.
After the input, you have to press the DATE INPUT button to enter
the specified date into the system.