Transport And Storage; Surface Protection; Packing; Disassembly/Repacking - Pilous ARG 105 mobil Instruction Manual

1. Transport and storage

You can transport and lift the machine only with a forklift. THE USE OF A CRANE PROHIBITED!

1.1. Surface Protection

Machine parts are protected against corrosion by powder coating or a primer and two-component polyurethane varnish. Sliding
surfaces are coated with anti-corrosive oil. Surfaces of other parts and components of the machine are treated by galvanization or
blackening.

1.2. Packing

ARG 105 Mobil is shipped in a carton, other types are attached by screws to a EUR pallet which can be adapted as a casing or
overseas box. The distance between the package and the floor is approximately 100 mm, which enables handling and transportation
by a forklift. The machine is packed in a stretching foil that protects it against weather influence during transport.
Standard accessories:
1 bimetallic saw blade M42 (installed),
1 band saw instruction manual,
1 length stop.

1.3. Disassembly/Repacking

Disconnect the machine from the mains • empty and clean the metal chip tank and the coolant tank • clean the machine • apply
anticorrosive oil on the sliding surfaces • fix the arm for transport • lift the machine and screw on the EUR pallet • make sure that all
protective covers of the machine are in place and fastened • add the machine accessories.

1.4. Disposal

When the machine has been definitely put out of operation, it should be disposed of in accordance with the provisions valid in the
respective country. We recommend that you contact a specialist waste disposal service.
DANGER OF DAMAGE !
Caution: used coolants belong to the category of special waste!
Only a person with adequate electrician qualifications can disconnect the machine
from the mains!