Pilous ARG 330 SAF Instruction Manual page 30

CONTROL HEAD
FIXED GUIDE HEAD
GUIDE HEAD TILT SETTING SCREWS
MOVING GUIDE HEAD
BOLT OF FIXED HARDENED STEEL BLADE GUIDES
Guideheads without saw blade feed pressure control
You can achieve the correct height of guide head in relation to the saw blade using the screws to set the upper bearing by 0.3-1 mm
closer to the saw blade than the hardened steel blade guides. In this case, there will be no clearance between the upper bearing and
the blade edge and the bearing will be carried along by the blade.
Set the guide heads perpendicular to the bars and tighten them. If you fail to achieve perpendicularity, the saw blade will either keep
sliding off or running into the wheels. Install the protective covers of the saw blade and close the back cover of the arm. Turn on the
MAIN SWITCH or connect the machine to the mains. Carry out a saw blade trial run. Switch off the MAIN SWITCH or disconnect the
machine from the mains and secure it against restart. Remove the protective covers of the saw blade and open/remove the back
cover of the arm. Check the placement of the saw blade on the wheels and in guide heads. Make a correction, if necessary - see
section 4.7.. Install the protective covers of the blade, close the back cover of the arm and turn on the MAIN SWITCH or connect the
machine to the mains. Carry out the cutting. You can watch the video with instructions on www.pilous.cz.
HARDENED STEEL BLADE GUIDES PRESSURE SCREW
CONTROL SYSTEM BEARINGS
CONTROL SYSTEM ROLLER
GUIDE HEAD BOLT
MOVING GUIDE HEAD
FIXED GUIDE HEAD