Smappee Pro Installation Manual page 18

Follow the Instructions on the Screen, then Cancel
Then, continue with these steps:
1. Start the installation in the App (see previous paragraph)
2. Follow the instructions, until you reach the screen "We will now configure your
Smappee by asking you a few questions..."
3. Press "Cancel" in this screen. You will now see the
bubbles "Install" and "Logout"
4. Press the "Logout" bubble.
5. Login again with the same user name.
6. You should now see three bubbles with the metering values.
Check the Success
This step is successfully complete when:
1. The Smappee shows a Green Breathing light.
2. The App shows bubbles with some (not yet necessarily accurate) consumption
values, such as "3 W"
If these conditions are met, please continue the installation at section "Configure the
Smappee in the Expert Portal ", on page 21.
Otherwise, consult the section "Troubleshooting Internet and Cloud Access" on the next
page.
Smappee Pro Installation Manual
Version 1.6.1, 12-05-2017, rev 226
Page 18 of 32