Table of Contents
Advertisement
Use a fitting device to fit the input or output elements.
Figure 4-2
Observe the correct mounting arrangement to minimize stress on shafts and bearings due to
lateral forces.
Correct
a
F
Figure 4-3
Procedure
1. Use either benzine or solvent to remove the anti-corrosion protection from the shaft ends
and flanges or remove the applied protective skin.
2. Fit the drive input and output elements to the shafts. Fasten the elements when
necessary.
You have now fitted the input or output element.
BA 2012
Operating Instructions, 02/2018, A5E38093971A/RS-AB
Example of a fitting device
Hub
Force
Mounting arrangement for low stress on shafts and bearings
4.7 Mounting an input or output element on the gearbox shaft
Incorrect
Installation
21
Advertisement
Table of Contents
