Installation
4.9 Installing and removing the shaft-mounted gearbox
4.9.2
Mounting the hollow shaft with feather key
*
①
②
③
④
⑤
Figure 4-5
Procedure
1. Use benzine or a solvent to remove the anti-corrosion protection from the shaft ends and
flanges.
2. Check the seats or edges of the hollow and machine shaft / plug-in shaft for damage.
Contact Technical Support if you notice any damage.
3. Apply the mounting paste
uniformly.
4. Fit the gearbox using the disk
the hollow shaft
5. Replace the nut
the specified torque.
6. Close the open hollow shaft end using a sealing cap
You have now mounted the hollow shaft with feather key.
Table 4- 2
Thread size
Tightening torque [Nm]
24
Not included in scope of supply
Machine shaft / plug-in shaft
Hollow shaft
Hexagon nut
Threaded spindle
Disk
Mounting the hollow shaft with feather key
②
.
③
and the threaded spindle
Tightening torque for the screw
⑥
Circlip
⑦
Feather key
⑧
Mounting paste
⑨
Screw
⑩
Sealing caps
⑦
to the machine shaft / plug-in shaft
⑤
, threaded spindle
④
with a screw
M5
5
Operating Instructions, 02/2018, A5E38093971A/RS-AB
①
. Apply the paste
④
③
and nut
. Support is provided by
⑨
. Tighten the screw
⑩
.
M6
M8
8
8
⑨
to
M10
14
BA 2012