Reading Out Measured Values - Siemens SENTRON 7KM Product Manual

Commissioning

5.4 Reading out measured values

5.4 Reading out measured values
The expansion module measured values can be read out either directly on the PAC display, or
via the communication interface of the PAC device using the SENTRON powerconfig
configuration software, or by means of a Modbus command.
The SENTRON powerconfig configuration software can be downloaded from the Industry
Online Support website (https://support.industry.siemens.com/cs/ww/en/view/63452759).
Reading out from PAC device
In the menu "EXPANSION MODULES", call the "I(N) I(DIFF) ANALOG" from which you want to
read measured values and then select menu item "MEASUREMENT".
See the flowchart in chapter Setting the expansion module parameters (Page 26)
The following module information can be found in menu item "I(N) I(DIFF) ANALOG":
• MLFB number
• Serial number
• Firmware version
• Diagnostics
Measured values of the module are displayed in menu item "Measurement".
The parameters of the expansion module inputs can be set in menu item "Settings". For more
information refer to chapter Setting the expansion module parameters (Page 26).
30
Equipment Manual, 05/2020, L1V30408520AG-03