Advertisement
Figure 6
3. Route Ethernet cable(s) through the back of the mount housing, as shown in
the cable(s) to the ENET0 and/or ENET1 port on the back of the access point.
4. Once the cable(s) is/are connected to the access point, align the pins on the rear panel of the access point
with the mount housing slots. Press the button on the bottom of the mount housing and slide the access
point into the slots. Release the button to secure the access point to the mounting bracket. See
Figure 7
5. To lock the access point to the mounting bracket, insert the T6 M2 x 6mm pan head screw into the hole
beside the button, located at the bottom of the mount. Then tighten until the screw is snug.
4
Installing the mounting bracket to a dual-gang wall box
Securing the access point to the mounting bracket
Figure 5
and
Figure
6. Connect
Figure
7.
AP-220-MNT-W3
| Installation Guide
Advertisement
