Advertisement
3. Once the holes have been drilled, remove the drill template and position the mounting bracket flat against
the surface. Align the holes of the mounting bracket with the pre-drilled holes, then screw the housing into
place.
Screws for
4. Press the RJ45 coupler(s) into the housing(s) located in the upper corner(s) of the mounting bracket until
snapped into place in the housing(s), as shown in
Figure 2
5. Insert one end of the Ethernet cable into the couplers as shown in
Figure 3
6. Plug in the opposite end of the cable into the ENET0/ENET1 port, located on the back of the access points.
7. Once the RJ45 cable(s) are attached, align the pins on the back panel of the access point with the
corresponding slots on the mounting bracket. Press the button on the bottom of the mounting bracket to lift
raise the slots and slide the pins into the bracket. Release the button to secure the access point to the mount,
as shown in
2
step 3
are not included in this kit and may vary depending on the surface type.
Attaching the RJ45 couplers to the mount
Inserting Ethernet cable into RJ45 coupler
Figure
4.
Figure
2.
Figure
3.
AP-220-MNT-W3
| Installation Guide
Advertisement
