Table of Contents
Advertisement
1.
Interrupt the operation (
2.
If necessary, secure material pressure pump or material pressure container for the spray
media against restart.
Fig. 6: Cleaning the hand-held spray gun
3.
Fill solvent into the fluid cup ( Fig. 6/1).
4.
Switch on the compressed air supply.
5.
Where applicable, switch on material pressure pump or material pressure container for
spray media.
6.
WARNING!
Sound pressure level
Depending on the operating conditions, the sound pressure of the hand-held spray gun
may cause hearing damage.
Start spraying process by activating the pull lever ( Fig. 6/2).
7.
Spray until the cleaning product runs clear.
8.
End the spraying process by releasing the pull lever ( Fig. 6/2).
9.
End the supply of the cleaning product.
10.
Remove the fluid cup.
GB–28
Operating instructions
Ä Chapter 7.5 'Shutting down' on page 23).
T-Dok-242-GB-Rev.0
mail@krautzberger.com, www.krautzberger.com
Advertisement
Table of Contents
