Siemens SIMATIC ET 200SP HA Equipment Manual page 19

Required accessories
● If you are fabricating the IE FC FO Cable with the IE FC LC plug, we recommend you use
the FC FO termination kit; for FC LC plug. You precisely break (cleave) the glass fibers with
the supplied tool.
● LC plug connector for PROFINET connection: IE FC LC Plug (10 duplex plugs:
6GK1900-1RB00-2AB0)
● Cables
Maximum length of the PROFINET IO cables: 3 km
Requirements
● Fabricate the PROFINET IO cables (connect fiber-optic cables to LC plug connectors).
You can find information about the tools required for specific cables in the system manual
"SIMATIC NET; Industrial Ethernet / PROFINET; Passive Network Components
support.industry.siemens.com/cs/ww/en/view/84922825)".
● If the device is the last node of the FOC network, you need to terminate the unoccupied FOC
interface with a blanking plug. When the modules ship, the blanking plugs are inserted in the
PROFINET sockets of the BusAdapter.
NOTICE
Derating when using a redundant ET 200SP HA
When using a redundant ET 200SP HA, read the information about the permissible ambient
temperature.
Required tools
Screwdriver:
● TORX T10
or
● 3.5 mm blade width
BusAdapter for Distributed I/O
Equipment Manual, 09/2019, A5E39261458-AB
CAUTION
Cleaving the glassfiber
● Wear protective glasses during the cleaving process.
● Dispose of the remaining fibers in a suitable waste container.
Cable type
FO Standard Cable GP
FO Trailing Cable
FO Robust Cable GP
Installation
4.4 BusAdapter BA 2xLC
Article number
6XV1847-2A
6XV1847-2C
6XV1873-5R
(https://
19