Busadapter Ba 2Xrj45 - Siemens SIMATIC ET 200SP HA Equipment Manual

4.5

BusAdapter BA 2xRJ45

Introduction
Plug Front view
4
You connect the IO device to the PROFINET IO system via the BusAdapter BA 2×RJ45 with
Industrial Ethernet cables.
Required tools
Screwdriver:
● TORX T10
or
● 3.5 mm blade width
Installing the RJ45 connector
You can use FastConnect cables with the "IE FC RJ45 Plug 180" connector when installed in
an enclosure.
You can find information on this in the system manual "SIMATIC NET; Industrial Ethernet /
PROFINET; Passive Network Components
view/84922825)".
Installing a BusAdapter to distributed I/O
To connect PROFINET IO to the device via the BusAdapter BA 2×RJ45, proceed as follows:
1. Plug in the BusAdapter BA 2×RJ45 and screw it tight.
2. Insert the RJ45 connector(s) into the PROFINET port on BusAdapter BA 2×RJ45.
3. Secure the PROFINET IO cable to protect the plug from pulling.
BusAdapter for Distributed I/O
Equipment Manual, 09/2019, A5E39261458-AB
3
Description
①
LED LK 1 - Status of Ethernet connection port 1
5
②
LED LK 2 - Status of Ethernet connection port 2
You can find information on this in section "Diagnostics via LED
displays (Page 29)".
③
Connection diagram for the PROFINET connectors (view
from below)
④
Fixing screw
⑤
Tightening torque
1
2
(https://support.industry.siemens.com/cs/ww/en/
Installation
4.5 BusAdapter BA 2xRJ45
21