Siemens SIMATIC ET 200SP HA Equipment Manual page 17

1. Install the FC cable to the BusAdapter.
2. Plug in the BusAdapter and screw it tight.
3. Secure the PROFINET IO cable to protect the plug from pulling.
Installing BusAdapter BA 2×FC
Note
The figure below is a basic representation using the ET 200SP HA as an example; it is also valid
for other distributed I/O devices.
①
②
③
④
Figure 4-3
Note
Configuration guidelines for modules with PROFINET IO interfaces
Only when all connected nodes are equipped with a SELV/PELV power supply (or have
equivalent protection) is it permitted to operate the modules with PROFINET IO interfaces in
LANs (Local Area Networks).
A data transfer point is prescribed for connection to the WAN (Wide Area Network) that
guarantees this degree of safety.
Additional information
● System manual "SIMATIC NET; Industrial Ethernet / PROFINET; Passive Network
Components (https://support.industry.siemens.com/cs/ww/en/view/84922825)"
● Pin assignment of the FC outlet (4-pin connector) (Page 32)
BusAdapter for Distributed I/O
Equipment Manual, 09/2019, A5E39261458-AB
BusAdapter BA 2×FC
FC connection element
PROFINET IO cable
Interface module
Connecting a PROFINET IO cable to the device via BusAdapter BA 2×FC
Installation
4.3 BusAdapter BA 2xFC
17