4 OPERATION
4.7.2
For single wire < 1.6 mm (D35)
Use automatic welding equipment A2TG J1
(MIG/MAG) where the following are included:
•
Wire feed unit (1)
•
Connector D35 (2)
•
Contact tip (3) (M12 thread)
•
Guide tubes (4)
Tighten the contact tip (3) with a key in order to ensure
that a good contact is achieved.
4.7.2.1
Accessories
•
Fine-wire straightener (5) to be fitted on top of the clamp of the
wire feed unit (1).
NOTE!
When mounting the fine-wire straightener, remove the
plate (7) if it exists.
NOTE!
Do not remove the protection plate (8).
4.7.3
For single wire 1.0–2.4 mm (wire feed unit with four-wheel drive)
Use automatic welding equipment A2TG J1 4WD
(MIG/MAG) where the following are included:
•
Wire feed unit (5)
•
Contact device D35 (6)
Tighten the contact device (6) using the Allen
screw (8).
•
Contact nozzle (7)
Tighten the contact nozzle in order to ensure that
a good contact is achieved.
Select a wire guide insert of the correct dimension for
the type of wire to be used. See the instruction manual
for contact device MTW 600 (0449 006 xxx).
0449 165 160
- 22 -
© ESAB AB 2020