How To Start A Multiconference - Aethra Vega X3 Use And Installation Manual

Mode (only for MCU ISDN or Mixed)
Multiple of 64K
Multiple of 56K.
Master or Slave Cascade Role.
This option allows you to set up cascaded MCUs in a two-level hierarchy tree. Corresponding
to the base node of the cascade there is the Master System, with Slave Systems for the child
nodes.

How to start a multiconference

To establish a multiconference:
1. From the Home Page, select the VIDEO icon, or press the "Call" key on the remote control.
You will enter the Audio-Video calls page.
2. Choose desired MultiConference type: MCU IP, MCU ISDN, MCU (mixed mode).
3. Chose the desired rate and number of participants.
4. If the MCU has not been configured, it is possible to enter the configuration menu previously
described by selecting the CONFIGURE MCU icon and pressing OK.
5. If the MCU has already been configured, go to the "Active Conference" icon and press OK to
start the multiconference. The same can be obtained by pressing the "CALL" key on the remote
control.
6. Local video will be displayed at full screen.
7. To add participants, press the remote control "CALL" key
8. To disconnect participants, press the remote control "DISCONNECT" key.
75