Multiconference Setup - Aethra Vega X3 Use And Installation Manual

Multiconference Setup

Before activating a multiconference session, configuration is required.
From the Home Page select:
1. SETTINGS
2. MULTICONFERENCE
The following will be displayed:
In this menu you can set:
Network Type: IP, ISDN or Mixed.
Conference Type: allows you to select the number of participants and the desired rate
(example: for an MCU IP you select 8@256 from the drop-down menu, which means that the
MCU will allow the System to manage a multiconference with a maximum of 8 terminals
(including itself), via IP, with a maximum rate of 256K for each connection).
Preferred Audio Coding
Preferred Video Coding
Go to the corresponding drop-down menu, press OK, with the aid of the arrow keys on the remote
control make your selection and press OK again to confirm. <Auto> is the default setting.
In addition, you can select the following options:
Dual Video H.239.
G.722.1.
Automatic rate adaptation and automatic encoding adaptation
If automatic adaptation is enabled, the System will automatically adapt the multiconference to
the audio/video encoding and bit rate of the lowest quality connection within the conference,
without excluding any participant.
Continuous presence
Enable/Disable transmission of Continuous presence: for multiconferences (at least two
participants) all participating sites receive the signals simultaneously from all participating
terminals.
Ask to save scenario:
At the close of the multiconference, the system asks whether save in the phonebook all
information needed to repeat it, with an editable "conference name."
74