Aethra Vega X3 Use And Installation Manual page 76

H.243 function
From the fullscreen page of MCU manager or a participant terminal is possible to get MCU control,
conforming to H.243 protocol, by pressing the BLUE key.
A page will appear, where is possible to:
Request Chair control
•
Close conference
Send local on air
For each terminal in the list
•
Information: connected users
•
See
•
Send on air
•
Disconnect
Remote terminals disposition and visualization
With MCU on and various connected terminals, is possible to choose disposition and how many video
flows should be displayed. From the fullscreen page of the manager, press right or left keys to select the
"terminals disposition" icon, and press OK.
Once the window is opened:
3. By means of up and down keys choose the visualization mode, then confirm selection with OK
key.
4. Close the window by means of the OK icon, or with the X icon to discard selection.
Note
If Continuous Presence transmission is enabled in configuration (see Multiconference
setup chapter), "terminal disposition" is sent to all terminals
"Terminals disposition" icon
"Video Zoom +" icon
"Video Zoom -" icon
76