How To Program Trigger Source Of Dry Output Contact; How To Get Ags Function; How To Restore Factory Setting - TBB Energier Apollo CH2.0M User Manual

6.7 How to program trigger source of dry output contact

Energier Apollo is equipped with two programmable relay that are set by default as a battery low
alarm relay. However the relay can be programmed for all kinds of other applications.
General
Advanced

6.8 How to get AGS function

Refer to 6.7, set for AGS function setting please use Rapconfig "AGS" generator condition.
For example as a starter relay for a generator, user can set programmable relay as AGS on Rapconfig
software with PC.

6.9 How to restore factory setting

For restore factory setting, please refer to chapter 5.4.6 system control.
Rated voltage
Enter
ESC
230V
Energier Apollo User Manual
Page
down x 8
Page up
Settable optional:
Battery low
Overload
Over temperature
Output short
Over charge
Inverter fault
Fan running
AGS
46
Auxiliary out1
Battery Low
Auxiliary out2
Battery Low