Table of Contents
Advertisement
Flue components
Due to heat from the flue components, maintain 25 mm clearance to combustibles for the first 500 mm of flue
Direct flue kit - ASPDFK (aluminium)
Suitable for walls up to 385 mm thick (can be cut to length). Can also
be used with ESPIPE900 for longer flueing. The minimum length when
measured from the back plate of the transition casting MUST NOT be less
than 300 mm when joining to other components.
540 mm
Ø 75 mm
50 mm
45° flue bends - ESBEND
Two bends in a kit. Can be used
separately, or together as a 90° bend.
Refer additional images on p.19-20.
Spacers are mandatory to
ensure alignment of the flue
and to stop the outer bends
overheating
Flue pipe - ESPIPE900
Extension pipe used for horizontal,
vertical, and downwards flueing. Can
be cut to size at the non-socketed
end.
Inner is aluminium, outer white PVC.
Comes with a wall bracket, o-ring
(4350), and spacer (4351).
10 | Linear flue installation guide 13541-A 01-20
Not pictured is the
internal white wall plate
Wall terminal kit - ESWTERM
Used to terminate the ESPIPE900
in horizontal flue installations when
used with LSFKIT01.
Roof terminal - ESROOFCOWL
Roof cowl and connecting pipe for
termination of a vertical flue—can
be cut to size. 500 mm clearance
required from any part of the
building, refer p.5.
Galvanised steel, powder coated
black.
Adaption flue kit - LSFKIT01
Includes flue adaptor, flue extension,
standoff bracket, flue slide stopper
(4822), O-ring silicone grease.
77 mm
Transition extension - LSFEXTKIT01
Flue transition extension, MUST BE
used with the ASPDFK before any
bends, for example in side and back
flueing. When connected overall
length reduces 45 mm each end.
Wall plate - ESPLATE
Used in down and out flueing to cover
the floor penetration, and also as an
extra wall cover if required, to tidy up an
installation. Outer diameter 170 mm.
115 mm
Advertisement
Table of Contents
