Table of Contents
Advertisement
LAN
A Local Area Network (LAN) is a shared communication system to which many computers are attached
and is limited to the immediate area, usually the same building or floor of a building.
IPv4 Parameters
IP Address: Enter the IP address of Router in dotted decimal notation, for example, 192.168.1.254
(factory default).
IP Subnet Mask: The default is 255.255.255.0. User can change it to other such as 255.255.255.128.
Alias IP Address: This is for local networks virtual IP interface. Specify an IP address on this virtual
interface.
Alias IP Subnet Mask: Specify a subnet mask on this virtual interface.
IGMP Snooping: Select Activated to enable IGMP Snooping function, Without IGMP snooping,
multicast traffic is treated in the same manner as broadcast traffic - that is, it is forwarded to all ports.
With IGMP snooping, multicast traffic of a group is only forwarded to ports that have members of that
group.
Dynamic Route:
RIP Version: (Routing Information protocol) Select this option to specify the RIP version,
including RIP-1, RIP-2.
RIP Direction: Select this option to specify the RIP direction.
None is for disabling the RIP function.
-
Both means the router will periodically send routing information and accept routing
-
information then incorporate into routing table.
IN only means the router will only accept but will not send RIP packet.
-
OUT only means the router will only send but will not accept RIP packet.
-
DHCPv4 Server
BEC 4700A / 4700AZ User Manual
Device Configuration
Interface Setup – LAN
71
Advertisement
Table of Contents
