Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for BEC EG-210N
Summary of Contents for BEC EG-210N
- Page 1 BEC EG-210N ® GigaConnect Smart Gateway Quick Start Guide...
- Page 3 INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE. IF YOU NEED MORE INFORMATION ON THIS SOFTWARE CONFIGURATION, PLEASE REFER TO THE ONLINE USER MANUAL. Package Contents ✓ BEC EG-210N Smart Router * 1 ✓ This Quick Start Guide * 1 ✓ RJ-45 Ethernet Cable * 1 ✓...
-
Page 4: Front Panel Leds
Data being transmitted / received blinking Wireless Orange WPS configuration is in progress Green IP address has received; traffic is passing thru the device. IP address request has failed. Internet EG-210N is either in bridged mode or WAN connection not ready. -
Page 5: Rear Panel Connectors
® BEC EG-210N GigaConnect Smart Gateway Rear Panel Connectors INTERFACE MEANING Wi-Fi Antenna Screw the supplied Wi-Fi antennas onto the antenna connectors on both sides Connectors Power Button Power ON/OFF switch Power Jack Plug in the supplied Power Adapter to this jack... -
Page 6: Hardware Connection
Quick Start Guide Hardware Connection Hardware Installation 1. Power Connection Plug in the supplied power adapter to the wall jack, the other side to the EG-210N then power it ON the by pressing the Power On/Off button. - Page 7 Plug the RJ-45 Ethernet cable to one of the Ethernet ports, and the other side to the PC’s Ethernet interface. 3. WAN Link Interface and Connection BEC EG-210N supports failover and failback on dual WAN interfaces, Ethernet WAN and Wi-Fi WAN. <Please refer to User Manual for detailed Internet setup> 3.1 Ethernet WAN Connection...
- Page 8 Quick Start Guide 3.2 Wi-Fi WAN Connection Go to the device GUI / Interface Setup / Internet setting to connect to a Wireless Access Point as the WAN interface or Wireless Service Provider to the Internet.
-
Page 9: Connecting To The Router
Quick Setup Your Router Use the Quick Start for fast connection setup. Wired Broadband Connection - before start configuring the EG-210N, make sure you have the LAN2/WAN connect to your Internet box/modem or fiber line. Step 1: Change administration password Setup a new password for “admin”... - Page 10 Quick Start Guide Step 3: Setup Local Wireless Connection Access Point: select Activated SSID: Assign a unique name Channel: pick from 1~11 Security Type: select a mode - Disable (No security) - WPA - WPA2 (Most secure one) - WPA / WPA2 (auto detect WPA mode with wireless clients) - WEP (Less secure one) Pre-Shared Key: key for wireless authentication...
-
Page 11: Troubleshooting
® BEC EG-210N GigaConnect Smart Gateway Troubleshooting 1. None of the LEDs are on when you turn on the router. Check the connection between the adapter and the router. If the error persists, you may have a hardware problem. In this case you should contact technical support.
Need help?
Do you have a question about the EG-210N and is the answer not in the manual?
Questions and answers