Adaptec RAID 2120S Installation And User Manual page 44

9 To enable RAID management software and utilities, type the
following commands:
cd mount-point/openserv/arc/driver/aacraid/reloc/tmp/aacraid/scripts
cp ./aacaifd /usr/sbin
cp ./S98aacaifd /etc/rc2.d
chmod 755 /usr/sbin/aacaifd /etc/rc.d/S98aacaifd
Installing the Driver in an Existing OpenServer System
To install the driver in an existing operating system:
1 Install and configure your Adaptec RAID controller and hard
drives, as described in
2 Create the driver disk, as described on
remove the driver disk.
3 Boot the server.
4 Insert the driver floppy disk.
5 To run the
installpkg
the
installpkg
OpenServer reads the disk and performs the installation.
6 Rebuild the kernel.
7 Install the new kernel by typing y when prompted to make it
the default kernel.
8 Restart the computer.
9 Add devices created on the RAID controller to the operating
system. For details, refer to your OpenServer documentation.
10 Insert and mount the Adaptec installation CD.
11 To enable RAID management software and utilities, type the
following commands:
cd mount-point/openserv/arc/driver/aacraid/reloc/tmp/aacraid/scripts
cp ./aacaifd /usr/sbin
cp ./S98aacaifd /etc/rc2.d
chmod 755 /usr/sbin/aacaifd /etc/rc.d/S98aacaifd
Chapter
utility, open a terminal window and type
command.
2.
page 3-2. When finished,
Installing the Driver
3-7