Installing With Windows Server 2003 Or Windows Xp; Installing With Windows Server 2008 Or Windows Vista - Adaptec 51645 Installation And User Manual

Installing with Windows Server 2003 or Windows XP

To install the Adaptec RAID controller driver while installing Windows:
Insert your Windows CD, then restart the computer.
1
Follow the on-screen instructions to begin the Windows installation.
2
When prompted to install a third-party driver, press F6.
3
Note:
When F6 is active, a prompt appears at the bottom of the screen for only 5 seconds.
If you miss your chance to press F6, restart your computer.
Insert the driver disk, then wait until you are prompted to install a driver.
4
Press S to specify that the driver is on a floppy disk, then press Enter.
5
The computer reads the disk.
When the Adaptec driver is found, press Enter.
6
Follow the on-screen instructions to complete the installation.
7
Continue with Managing Your Storage Space on page
8

Installing with Windows Server 2008 or Windows Vista

To install the Adaptec RAID controller driver while installing Windows:
Insert your Windows CD, then restart the computer.
1
Follow the on-screen instructions to begin the Windows installation.
2
When prompted to specify a location for Windows, select Load Driver.
3
Insert the Adaptec Installation CD, then click OK.
4
When the Adaptec driver is found, press Next.
5
Click Next again to accept the default partition configuration, or refer to your Windows
6
documentation to configure partitions manually.
Follow the on-screen instructions to complete the installation.
7
Continue with Managing Your Storage Space on page
8
Chapter 7: Installing the Driver and an Operating System
59.
59.
50
●