Using The Adaptec Installation Cd - Adaptec RAID 2120S Installation And User Manual

13 On the next screen, respond as follows:
Property Line Displayed
Array Type
Array Label
Array Size
Stripe Size
Read Caching
Write Caching
Create RAID via
[Done]
A Creating Array window appears.
14 Press Enter to continue with the array configuration.
Note: You can start using the array immediately. However,
performance is reduced until the build process is complete.
15 Press Esc until the Exit Utility window appears.
16 Highlight Yes, then press Enter.
The system restarts.
17 Install the driver as described in

Using the Adaptec Installation CD

Note: SCSI only—You cannot create the RAID using a CD
drive connected to the RAID controller.
To build a bootable RAID 5 array using the Adaptec installation CD:
1 Install the controller and drives, as described in
Controller and Drives on page
Start or restart the computer.
2
Installing the Controller and Drives
Entry or Selection
Select RAID 5, then press Enter
Type a name, then press Enter.
Press Enter, then press Enter again to
use the default granularity of GB.
Press Enter.
Press Enter.
Press Enter.
Press Enter.
Press Enter.
Chapter
2-3.
3.
Installing the
2-7