Before Using Audiocodes Devices - AudioCodes 400HD Series User's And Administrator's Manual

CHAPTER 2 Setting up the Phone
If the phone model you have has an Expansion Module attached, wall mounting isn't
supported.
➢ To mount the phone on a wall:
1. Attach the stand of the phone for the purpose of a wall mounting:
a. Detach the base.
b. Attach it again as you did for a desktop mounting (see Desktop Mounting on the
previous page ) only now make sure that it's flatly aligned to lie flush against the wall,
i.e., slide the inner rails of the phone stand onto the phone base's inner notches.
2.
Connect the AC power adapter, LAN and PC/laptop cords.
3. In the wall, drill two horizontal holes at a distance of 4 7/8 inches (123.8 mm) from one
another, in line with the template.
4. Insert two masonry anchors into the holes if necessary.
5. Thread two screws (not supplied) into the two masonary anchors; ensure that the heads
extend sufficiently (about 3/16 inch or 5 mm from the wall) for the phone stand's keyhole
slots to hang on.
6.
Hang the phone stand's keyhole slots on these screws.

Before Using AudioCodes Devices

AudioCodes recommends frequently cleaning devices' touch screens especially the screens on
devices in common use areas such as conference rooms and lobbies.
➢ To clean a device's touch screen:
1. Disconnect all cables.
2. Spray onto a clean, dry, microfiber duster a medicinal isopropyl alcohol and water solution
of 70:30. Don't oversaturate the duster. If it's wet, squeeze it out.
C448HD and C450HD | Users & Administrator's Manual
- 16 -