Removing the Adapter
You must use the Unplug or Eject Hardware Wizard to properly
disconnect your DuoConnect for Notebooks adapter from your
computer.
To disconnect the adapter:
1 Stop and disconnect all devices connected to the adapter. (Refer
to your devices' documentation for instructions, if required.)
2 Click the Unplug or Eject Hardware Wizard icon
(shown at right) on your system tray, which is in the
bottom right corner of your screen.
3 Click Texas Instruments OHCI Compliant IEEE 1394 Host
Controller, then click Stop.
Your system stops all four controllers on your DuoConnect for
Notebooks adapter. A message appears telling you that the
device has been stopped.
4 Click OK.
It is now safe to remove your DuoConnect for Notebooks
adapter.
Removing the Adapter
24