Overview - Magna Telemotive blue PiraT2 User Manual

3

Overview

This user guide describes the installation and usage of a system for video recording. It consists
of one network camera AXIS P12-series / F-series / 211 / 210 / 207 or a Video Encoder AXIS
Q7404 / P7214 with analog cameras and a one of the data logger

blue PiraT2

blue PiraT2 5E

blue PiraT Mini

blue PiraT Remote
Telemotive AG. The Video Encoders are used to connect analog cameras (NTSC/PAL). The
network cameras can be connected directly to the data logger.
The system allows the recording of up to four different video streams at the same time. For that
the server (or a network camera) and the data logger must be connected to each other and con-
figured separately by a HTML-based client.
The video streams are recorded in real-time and in a specified time interval in the logger. They
can be downloaded into a control unit for offline use. They can also be converted to a video file
and transferred from the logger into a computer. The video block length can be adjusted to 15
up to 60 seconds and the videos are stored in the mpeg4 format.
When converting into a video file, the system can combine a maximum of 400 blocks per file.
The length of the blocks can change. If more video blocks are available and they cannot be
converted to one file, the system creates several files. In this way no video data is lost.
Attention:
The Video Encoder and the cameras are not set by default to standby mode, which may
be a reason for an empty battery.
After rebooting the system takes approximately 60 seconds to be synchronized. The recording
starts immediately after the synchronization.
If the Ethernet cable was removed between the Video Encoder / camera and the data logger
and plugged in again, the system takes around 11 seconds for the resynchronization.
If the supply voltage is removed from the Video Encoder / camera during the recording, it takes
about 60 seconds to be synchronized (after a reconnection).
AXIS camera and Video Encoder should be operating within the AXIS specification. This is es-
pecially required for power and environmental parameters.
This user guide describes the configuration and usage of this feature. The general configuration
is described in the user guides of the used data logger as well as the Telemotive System Client,
which is valid together.
The client software was only tested with Microsoft
This document refers to firmware version 02.04.01 and the Telemotive System Client from
version 2.4.1. Some features depending on model and feature license or may not be available
in older versions.
Software updates and user guides for other, optional, licensed enhancements are available in
the Telemotive ServiceCenter. (Please find the address under Contact at the last page.)
bP2-Mini_Camera_UserGuide_V2.4.1.doc
blue PiraT2 / 5E / Mini
Camera User Guide
®
Windows
Datum: 16.09.2016
®
7.
Seite 6 von 77