Graco E-flo iQ 26B543 Installation-Parts page 28

Setup
Dispense Valve Solenoid
3. If using a Single iQ Ram Supply System:
a. Connect the solenoid valve cable (VC) to the
M8 4 pin end of the splitter cable attached to
Port 4 on the Electric Driver (AB). See Electric
Driver Communication Connections for
Single Rams on page 16. See F
b. Connect the 90 degree end of the included M8 4
pin cable (VD) to the dispense valve, and the
straight end of the solenoid valve cable to (VC).
See F . 24.
IG
4. If using an iQ Tandem Ram Supply System:
a. Connect the dispense valve solenoid cable to
the tandem dispense valve solenoid connector
(YY) on tandem block (R).
b. Connect the 90 degree end of the included M8 4
pin cable (15N040) to the dispense valve, and
the straight end of the solenoid valve cable to
(VC). See F
c. Connect one male end of the M8 4 pin splitter
(TT) on the tandem block (R) to the M8 4 pin
end of the splitter cable attached to Port 4 on
the Electric Driver (AB) for ram 1 and ram 2.
See Electric Driver Communication
Connections for Tandem Rams on page 17.
NOTE: Make sure the pins on the solenoid valve cable
are oriented as shown in F
plugged into the solenoid valve.
Solenoid Valve
F . 23
IG
28
IG
. 24.
IG
. 23 before the cable is
IG
Solenoid Valve
Cable
. 24.
PA
F . 24
IG
Robot Connection (if used)
5. If using a Single iQ Ram Supply System:
a. Connect the included M12 8 pin cable with
b. Flying leads of (128441) connect to robot
6. If using a Tandem iQ Ram Supply System:
a. Connect the included M12 8 pin cable with
b. Connect M12 8 pin discrete robot splitter (RR)
c. Flying leads from (128441) connect to robot
PC
NN
flying leads (128441) to Port C4 of the power
junction box (AJ)
controller (not included).
flying leads (128441) to discrete robot cable
connector (SS) on tandem block (R).
to Port C4 of the power junction box (AJ) on ram
1 and ram 2.
controller (not included).
VD
FT
B
3A8217A