Graco E-flo iQ 26B543 Installation-Parts page 26

Setup
c. Connect Tandem Hose 1 (L) and Tandem Hose
2 (M) from the supply system to the Tandem
Block (R). See F
d. Connect Supply Hose 1 (C) to the Tandem
Block (R). See F
F . 18
IG
C
M
F . 19
IG
6. If you are using two supply hoses (C and D), use the
Supply Hose 1 to Supply Hose 2 Fitting (F) to
connect Supply Hose 1 (C) to Supply Hose 2 (D).
See F . 20.
IG
NOTE: If using heated hoses, make sure the electrical
connections of each hose are oriented correctly, with
the circular electrical connector facing the Ram. See
F . 1 on page 9 for proper hose orientation on the
IG
system.
C
F . 20
IG
26
. 19.
IG
. 19.
IG
L, M, C
E, N, P
R
F
D
7. If two hoses are used, connect Supply Hose 2 (D) to
the inlet fitting on the Dispense Valve (B). If only one
hose is used, connect Supply Hose 1 (C) to the inlet
fitting on the Dispense Valve (B). See F
PC
F . 21
IG
8. Tighten all fittings until secure.
9. Connect the Air Line (AR) (not supplied) to the air
fitting (FT) on the dispense valve solenoid. See the
Axial Dispense Valve Instructions-Parts manual.
See F . 24.
IG
L
B
3A8217A
. 21.
IG
D