Table of Contents
Advertisement
2
Getting Started
DCC Port
Connector 9-pin miniature D-type.
Use this port to insert and drop either the D1-D3 DCC channel
or the D4-D12 DCC channel. The first bit of data inserted will be
put into the MSB of the DCC channel. The MSB of the dropped
data bytes will be output first. The transmit (drop) and receive
(insert) capabilities are independent, that is the transmit and
receive clock rates can be set to different rates. The instru-
ment acts as a DCE (Data Communications Equipment), sup-
plying the clock signal for both drop and insert operation.
Rates D1-D3 DCC: 192 kb/s, D4-D12 DCC: 576 kb/s
Signal Type Unipolar differential signal as defined in ANSI
EIA-422-B and EIA-423-B.
Input Termination 100 ohms differential.
Input Sensitivity 500 mV over a +/-15 V common mode
range and 200 mV over a +/-7 V range.
Pin Number
1
2
3
4
5
6
7
8
9
28
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
RS-449/422 Circuit
Rx Data Output (+)
Rx Clock Output (+)
Signal ground
Tx Clock Output (+)
Tx Data Input (+)
Rx Data Output (–)
Rx Clock Output (–)
Tx Clock Output (–)
Tx Data Input (+)
Transmission Test Set Quick Reference Guide
Advertisement
Table of Contents
