Program Settings - Seametrics TempHion Instructions Manual

OPERATION
Data files already downloaded will show
column, clicking here will bring you to the reports screen
to view the data. See Reports section for details.
You may only have 1 active data file recording on each
sensor, however you can store multiple files in memory if
desired.
Starting a new file will automatically terminate the active
logging and begin the new logging schedule. Real-time
data is available during active logging.
To delete files from memory make sure they have all been
downloaded to Reports. Files are removed from memory
all at once rather than individually.
Once confirmed files are permanently deleted from the
sensor memory.
Seametrics • 253.872.0284

Program Settings

in the Reports
To view/change Aqua4Plus settings click
side-bar menu.
Under the General Settings tab you can change the default
data folder location. This is where your Reports are saved
to on your PC.
The Zoom Factor slider can be used to adjust the font size
within Aqua4Plus.
Uncheck the Allow app to collect anonymous usage
statistics box if you would like to opt out. This information
is used to track Aqua4Plus reliability across different system
configurations.
Under the Display Units tab you can select your desired
display units for the supported channels. These may be
changed at any time and associated Real-Time readings
and Reports will rescale to the currently selected display
unit. To change Direct Read units scaling see Sensor
Settings.
Under the Communications tab you can change your
Modbus communication settings. Typically you will only
need to change the address range to connect to sensors
outside of Modbus address 1-10. In certain cases we
may need to change the Retry and Timeout settings to
overcome communication issues on very long, or corroded
cabling. See Troubleshooting section or contact Seametrics
Tech Support for details.
To restore factory default settings click
Page 17
TEMPHION INSTRUCTIONS
in the blue
seametrics.com