Initial Inspection And Handling; Do's And Don'ts - Seametrics TempHion Instructions Manual

GENERAL INFORMATION

Initial Inspection and Handling

Upon receipt of your smart sensor, inspect the shipping package for damage. If any damage is apparent, note the signs
of damage on the appropriate shipping form. After opening the carton, look for concealed damage, such as a cut cable.
If concealed damage is found, immediately file a claim with the carrier.
Check the label attached to the cable at the connector end for the proper cable length.

Do's and Don'ts

Do handle sensor with
care
Don't drop into well
Lower gently to prevent
damage
Seametrics • 253.872.0284
Do store sensor in
a dry, inside area
when not in use. (See
also "How to Store" in
Maintenance section)
Don't scrape cable
over edge of well
May nick or fray the
cable
  
  
Do install sensor so the
connector end is kept
dry
Don't bend cable sharply
May weaken internal wires
Page 6
TEMPHION INSTRUCTIONS
  
  
Don't support sensor
with the connector
Use a strain relief device
seametrics.com