Related Manuals for Aqua One Cabinet 53446
Summary of Contents for Aqua One Cabinet 53446
- Page 1 Assembly Instructions Please keep for future reference. AquaSys ReefSys 60cm Cabinet Suitable for AquaSys 150 or ReefSys 180 Aquariums Version 1 - 25/11/19 Important - Please read these instructions fully before starting assembly...
-
Page 2: Care And Maintenance
Safety Care and Advice IMPORTANT: Please read these instructions before starting assembly • Warning: This unit is heavy. • Make sure you have enough space • We do not Please lift with care. to layout the parts before starting. recommend the use of power drill/ •... - Page 3 Panels Please check you have all the panels listed below. 2x Side panels 2 x Wide back brace 764 x 530mm 764 x 200mm 1x Base 1x Top 604 x 531mm 604 x 531mm 1x Door 786x596mm...
- Page 4 Fittings Please check you have all the fittings listed below. 30x 15mm Large 30x Cam Bolts 4x Hinges Locking Cam Nut 4x Hinge Plates 6x Hammer-in Glides 12x 3.5x15mm Screws 2x Push Catch 1x Aperture Trim Ring...
- Page 5 Step One Lay side panels (A) on the floor with holes facing upwards. Fit 6x Cam fittings (1) into large holes with cross facing up and the arrow facing the edge of the board. Screw 3x Cam Bolts (2) into the 5mm holes along the back edge.
- Page 6 Step Two Fit Cam Fittings (1) into the 7 holes of the Wide Back Braces (B). Attach the raw edge of the Wide Back Braces to the back edge of the sides giving the Cam Fittings a half turn with the screwdriver.
- Page 7 Step Three Using a hammer, fit glides (5) to the underside of the base panel (C) using the pip marks as a guide for fitment then turn the base over to have the 5mm holes facing upwards. Screw in cam bolts (2) into all of the 5mm holes Turn over...
- Page 8 Step Four Drop sides with attached back braces onto the cams on the base ensuring the side that has the hinge plates is on the left hand side as you face it. Give all cam fittings a half turn with the screwdriver.
- Page 9 Step Five Lay top panel (D) with holes facing upwards, screw cam bolts (2) into all 5mm holes. Using 2 of screws (6) attach the bracket for the push catch (7) to the pip marks then attach push catch to the bracket by clipping in at the back and pushing down at the front until you hear a click.
- Page 10 Step Six Lay door (E) on floor with the hinge holes facing up, place hinges (3) into holes and screw in using remaining screws (6). Hook hinge arms into the front of the hinge plate and push in at the back of the arm until they click.
- Page 11 Step Seven From the inside of the cabinet push aperture trim ring (8) through the hole in the top of the cabinet. We highly recommenced securing with silicone to seal the edge and protect the chipboard.