Maintenance
•
Remove the oil drain plug and
discard the sealing washer.
B01165
1.
Oil drain plug
2.
Oil filter
•
Unscrew and remove the oil filter
using Triumph service tool T3880313
- Oil Filter Wrench. Dispose of the
old oil filter in an environmentally
friendly way.
•
Apply a thin smear of clean engine
oil to the sealing ring of the new oil
filter.
•
Install the oil filter and tighten to
89 lbf in
(10 Nm)
service tool T3880313 - Oil Filter
Wrench.
•
After the oil has completely drained
out, install a new sealing washer to
the drain plug. Install and tighten
the drain plug to 18 lbf ft (25 Nm).
•
Fill the engine with a 10W/40 or
10W/50
semi
motorcycle engine oil which meets
specification API SH (or higher) and
JASO MA, such as Castrol Power
1 Racing 4T 10W-40 (fully synthetic)
engine oil, sold as Castrol Power RS
Racing 4T 10W-40 (fully synthetic) in
some countries.
112
2
1
using
Triumph
or
fully
synthetic
•
Install the oil filter cover with the
wire guide in the same orientation
noted for removal. Tighten the
fastener to 27 lbf in (3 Nm).
•
Attach
the
connector to the oil filter cover.
•
Route the harnesses and hoses
through the wire guide as noted for
removal.
3
7
6
B01551
1.
Side stand switch connector
2.
Fastener
3.
Cover
4.
Wire guide
5.
Engine subharness
6.
Fuel tank drain hose
7.
Coolant expansion tank drain hose
•
Position
the
the crankcase with the coolant
expansion tank hose, fuel tank
vent hoses and the oxygen sensor
harness positioned as noted for
removal.
•
Note the lower left hand fixing also
secures the oil filter cover between
the sprocket cover and crankcase.
side
stand
switch
5
4
2
1
sprocket
cover
to