Maintenance; Storage - Max RB655 Operating And Maintenance Manual

7. MAINTAINANCE
q Regularly inspect the equipment
In order to maintain the performence of this equipment, periodically carry out cleaning and inspection
of the equipment.
w Do not lubricate the equipment
Absolutely do not lubricate this equipment. Applying lubrication will remove the enclosed grease, etc.
and will cause breakdown of the equipment.
Hook

8. STORAGE

Do not store the tool in a cold weather environment. Keep the tool in a warm area.
When not in use, the tool should be stored in a warm and dry place. Keep out of reach of children. All
quality tools will eventually require servicing or replacement of parts because of wear from normal use.
REMOVE REEL OF WIRE
When you have finished binding wires, remove the Tie-Wire from the tool.
STORE THE TOOL
When you have finished binding wires or when the tool will not be used for a while,
switch off the tool, make sure the Motor has stopped, lock the Trigger, and remove the
Battery pack, With a Pack cap installed on the Pack's terminal to prevent short circuits
tool, attachments, and accessories should be stored in a well-ventilated dry place where
the temperature will not exceed 50°C (122°F). The storage area must be locked and out
of the reach of children.
22
e Holding a Twist guide cover opened,
remove metal fragments and dust by
compressed air.
Blow in the compressed air at the angle
of 45˚ at the back of the tool.
Clean up the Hook.
45˚