Table of Contents
Advertisement
4 Maintenance and Lubrication
New Skin 2 model R2 do not require lubrication. To find out
if your Skin 2 is a model R2 check on the box labeled R2.
Every 80/100 hours of use lubricate the piston using VASELINE, a lubricating
cream made of pure paraffin for machine utensils. For lubrication push down
the piston, pass through the coil of the needle bar pin, apply a thin layer onto
the pin (above) and piston (below) using a small hex wrench. Lubricate also in
front and behind the piston where it joins the piston rod. Do not apply too much
lubricant, a small quantity is sufficient. Turn on the machine, regulate the power
unit to 11 volt and run the machine for a few minutes in order that the lubricate
is distributed to the whole piston.
Lubricate
every 80/100 hours
8
Advertisement
Table of Contents
