Antenna (2.4 Ghz & 5 Ghz) (Ant1), Holder (Antenna) - Sony HCD-SX7 Service Manual

HCD-SX7/SX7B
2-4. ANTENNA (2.4 GHz & 5 GHz) (ANT1), HOLDER (ANTENNA)
Note: When replacing the antenna (Ref. No. ANT1), refer to "CHECK-
ING OF NETWORK CONNECTION" on page 5.
3 Move the antenna cable to the rear side.
1 filament tape
(sub material)
2 wireless LAN
antenna connector
(CON4)
6 cover (ANT) block
14
4 two screws
(BTP2.6 6)
5 Remove the cover (ANT) block
in the direction of the arrow.
8 Draw the antenna wire
out of the hole.
0 screw
(BV/ring)
(L= 8 mm)
qd holder
(antenna)
card WLAN/BT combo
9 antenna (2.4 GHz & 5 GHz)
(ANT1)
qa boss
7 claw
qs Rotate the claw of holder
(antenna) in the direction of
the arrow, align the hole of
panel (back).
cushion (B)
filament tape
(sub material)
Note 1: Check that the wire
is not slack.
Note 2: Do not connect the
wire to the CON5.
claw
SYS SET