Plate (Top) Block - Sony HCD-SX7 Service Manual

HCD-SX7/SX7B
2-6.

PLATE (TOP) BLOCK

2 wireless LAN antenna
connector (CON4)
3 MAIN board CN606
cable connector
5 screw
(BV/ring)
(L=8 mm)
7 Draw the MAIN board
CN606 cable out from
the hole of the plate
(top).
16
1 filament tape
(sub material)
5 two screws (BV/ring)
(L=8 mm)
8 plate (top) block
5 two screws (BV/ring)
(L=8 mm)
6 Remove the plate (top)
block in the direction of
the arrow.
5 screw (BV/ring)
(L=8 mm)
4 Move the antenna cable
to the rear side.
card WLAN/BT combo
Insert the connector straight into the interior.
There is a possibility that using this unit without
the connector correctly installed will damage it.
OK NG
Insert straight into Insert only part way.
the interior.
connector
connector
connector connector
cushion (B)
filament tape
(sub material)
Note 1: Check that the wire
is not slack.
Note 2: Do not connect the
wire to the CON5.
NG
Insert at a slant.
connector
connector
SYS SET