Main Board-1 - Sony HCD-SX7 Service Manual

HCD-SX7/SX7B

2-18. MAIN BOARD-1

• Continued on 2-19 (page 25).
filament tape
(sub material)
ferrite core (FC3)
MAIN board
CN503
4 filament tape
(sub material)
5 flexible flat cable (6 pin)
(CN006)
terminal side
6 ferrite core
(FC2)
Note: To avoid touch with the lower side
of the chassis, paste this filament tape
so as to cover the flexible flat cable.
filament tape
(sub material)
ferrite core
(FC2)
filament tape
(sub material)
Insert the connector straight into the interior.
There is a possibility that using this unit without
the connector correctly installed will damage it.
OK
Insert straight into Insert only part way.
the interior.
connector
connector
connector
24
qa ferrite core
(FC3)
7 filament tape
(sub material)
terminal side
B
A
MAIN board
1 power unit cable
connector
(CN902)
NG NG
Insert at a slant.
connector
connector connector
0 flexible flat cable (24 pin)
(CN503)
terminal side
9 filament tape
(sub material)
8 flexible flat cable (5 pin)
(CN502)
qs optical pickup cable
connector (CN851)
terminal side
B
A
3 LCD flexible board
When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
MAIN board CN010
FAN motor cable is passed through
the cutout of the MAIN board.
qd FAN motor cable connector
(CN010)
2 flexible flat cable (6 pin)
(CN007)
terminal side
(CN002)
CN902
MAIN board
power unit
cable
NG
Insert at a slant.
flexible flat
cable
colored line
connector
SYS SET