2-12. BLUETOOTH MODULE (BT1)
filament tape
Bluetooth module
(sub material)
(BT1)
flexible flat cable
(FFC3)
How to install the flexible flat cable
When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
2-13. NETWORK BOARD
Note: Be sure to replace the complete NETWORK board and card WLAN/BT
combo at the same time. Be sure to also follow "NOTE OF REPLAC-
ING THE COMPLETE NETWORK BOARD AND CARD WLAN/BT
COMBO" on page 5 during replacement.
4 Remove the NETWORK board block
in the direction of the arrow.
2 Draw out the flexible flat
cable (10 pin) (FFC3)
from the hole.
NG
Insert at a slant.
flexible flat
cable
colored line
connector
6 radiation sheet (LUTE)
3 connector
(CN603)
3 filament tape
(sub material)
4 flexible flat cable
(10 pin) (FFC3)
1 four screws
2 heatsink (LUTE)
5 polyethylene washer
HCD-SX7/SX7B
1 screw
(BVTP2.6
5 Bluetooth module
(BT1)
terminal side
Front side
(BVTP2.6
8)
7 NETWORK board
8)
21
SYS SET