CAME AGT A200 Manual page 5

Function of terminals and jumpers
Terminal board A
Network
Terminal board B
+B Input 12 V DC 350 mA
5 Earth
21 Output 11 V DC
8 Common call output 1
8A Common call output 2
11 Audio from entry panel
12 Audio to entry panel
23 –
Output 14 V AC
16 +
NO Normally open
C Common
NC Normally closed
(*) The device is electronically protected against overloads and
short circuits.
Terminal board C
5 Earth
8 Audio to internal receiver
9 Audio to internal receiver
relay contacts
Technical data
Type
Power supply 50-60 Hz (V AC)
Power consumption (VA)
Output voltages at 11 V DC (mA)
Output voltages at 14 V AC (mA)
Peak output voltages (mA)
Operating output voltages (mA)
Storage temperature (°C)
Operating temperature (°C)
IP Rating
Installation
The device can be installed on DIN rails (EN 50022) on a suit-
•
able switchboard, or on the wall using the terminal covers.
☞
Ensure that the power supply cables are appropriately fi xed
in place, to avoid stresses, traction or twisting.
To dismantle the device, proceed as shown in fi gure 2-3.
•
See fi gure 1 for dimensions.
•
The power supply must always be installed horizontally.
Ensure there is correct ventilation if the power supply is
installed in a metal case.
A/200R
230
34
150
650
300
650 (1A)
-25 to +70
0 to +35
IP30