Sensor Connection; Pit Version; Lifting Platform Version; Switch-On/Switch-Off - Bosch FWA 46 + Series Original Instructions Manual

en | 36 | FWA 46xx + | Operation
4.5

Sensor connection

4.5.1

Pit version

¶
Position the sensor at the marked location and con-
nect up.
i
Details can be found in the separate "Commissio-
ning" document.
4.5.2

Lifting platform version

!
Before raising the platform, make sure the sensors
are properly attached to the adapter and that the
adapter has not worked loose.
!
Check the sensor handles regularly for damage.
!
The user may be at risk if the platform adapter has
not been fitted properly.
1. Connect the sensor, insert in the fixture and fold up.
Abb. 15: Platform adaption
2. Connect the 3 FWA 46xx + connectors to the sensor.
3. Fold down the sensor.
4. Switch on the PC.
"
FWA 46xx + is now ready for operation.
i
Checking
The FWA 46xx + always performs self-testing of all the
electronic components prior to the next wheel align-
ment operation.
Abb. 16: Sensor connections
|
1 690 706 098 2017-11-27
i
Make sure all plug-in contacts are firmly connected.
!
Make sure the three cables have been unplugged
before removing the sensors.
!
The sensors are only to be folded up for connection.
4.6

Switch-on/switch-off

1. Switch on the unit by way of the master switch on
the back panel of the housing.
2. Switch on the PC by way of the switch on the front.
"
The operating system runs up automatically.
i
Before switching off the unit, the FWA 46xx +
must be shut down by way of the Windows ope-
rating system. Prior to renewed switch-on, the
FWA 46xx + should have been switched off for at
least 60 seconds.
4.7

Online Help Wheel Alignment System

The Online Help is accessed by pressing the key "F1"
or the "Help" button. Online Help can be called up at
any time during measurement. The topic which appears
always relates to the current monitor display.
4.8

Software installation

The FWA 46xx + system software is already installed.
Updating of the system software is described in the
separate "Download" instructions.
4.9 Driving vehicle onto measurement
bay
1. Attach the turntables and sliding bases to the plat-
form.
2. Insert the locking pins of the turntables and sliding
bases.
3. Insert fillers.
Abb. 17: Filler
!
Make sure the vehicle is driven centrally and straight
on to the measurement bay.
!
Drive the vehicle onto the turntables and sliding
bases.
Robert Bosch GmbH