Program A Universal Tire Pressure Sensor - Bosch TPA 200 Original Instructions Manual

en 26 | TPA 200 | Operation
5.5 Program a universal tire
pressure sensor
This function is required, for example, if a faulty
tire pressure sensor is replaced by a new uni-
versal tire pressure sensor or if changing from
winter tires to summer tires. In the process, the
values of the existing tire pressure sensor is cop-
ied on to the new universal tire pressure sensor.
Another function is that the vehicle-specific sen-
sor ID generates TPA 200 to re-program a uni-
versal tire pressure sensor. The programming is
possible only for universal tire pressure sensors.
1. Switch on the TPA 200.
 Main Menu
is displayed.
 Check
is displayed.
2. Select "Prog. Sensors" with
confirm with .
 Vehicle >New Vehicle
(not in the case of operation sequence
"None").
i
If tests on vehicles have already been
performed and saved, and if the operation
sequence is set for "Job code", "Registration"
or "Model Year", these vehicles can be se-
lected again and tested.
3. Confirm with .

Select Make
4. Select " Select Make" with
confirm with .
 Select Model
5. Select " Select Model" with
confirm with .
 Select Year
6. Select " Select Year" with
confirm with .
 Select Sensor >EZ-Sensor
played (e.g. EZ sensor, depending on ve-
hicle).
7. Select "Select Sensor" with
confirm with .
 Select Option >Create Sensor
displayed.
i
At the moment, the replacement tire
pressure sensors do not cover all the tire
pressure sensors of the original equipment
manufacturer 100%. That is why it may hap-
pen that after the vehicle selection, there
is no programmable universal tire pressure
sensor available.The coverage increases each
time the software is updated.
|
1 689 989 200 2019-12-24
or and
is displayed
is displayed.
or and
is displayed.
or and
is displayed.
or and
is dis-
or and
is
There are now two options available:
R
Option Create Sensor to re-program a
universal tire pressure sensor with vehicle-
specific sensor ID.
R
Option Copy Sensor to copy the data from
a tire pressure sensor and program it onto
another tire pressure sensor.
Create Sensor
1. Select "Create Sensor" with
confirm with .
 e.g.
Place EZ-Sensor in front of TPA
is displayed.
2. TPA 200 place in front of the tire pressure
sensor and confirm with
 The "EZ programm." is performed.

Select Option >Create Sensor
displayed.
i
In the next step, a relearn procedure must be
done for the newly programmed tire pressure
sensor. The relearn procedure of tire pres-
sure sensor is dependent on the vehicle mod-
el. The options for relearn procedures for the
tire pressure sensor depending on vehicle
type are described in the TPA Startcenter.
3. Select "<Back" several times with
and confirm with
menu.
Copy Sensor
1. Select "Copy Sensor" with
confirm with .
 e.g. Read OE Sens.
2. Place the TPA 200 in front of the tire pres-
sure sensor and confirm with
 Data of the original tire pressure sensor
are copied.
 Place EZ-Sensor in front of TPA
is displayed.
3. Place the TPA 200 in front of the tire pressure
sensor on which the copied data is to be
programmed and confirm with
 The "EZ programm." is performed.
 Select Option >Copy Sensor
played.
4. Select "<Back" several times with
and confirm with
menu.
or and
.
is
or
to get into the main
or and
is displayed.
.
.
is dis-
or
to get into the main
Robert Bosch GmbH