Ricoh Ri 1000 Operator Training page 170

Monthly Maintenance
Clean and Re-apply Grease to the Guide Rods
At putting
0.01
～
0.02
ml
(hei
ght:
2mm
)
 Be sure to use the cleaning applicator and grease provided by
grease and applicators are designated for this this printer. Use of incorrect grease and the
accumulation of lint can cause the carriage to malfunction and need to be replaced if the
guide rods are not cleaned and greased correctly.
05/11/2020
After applying
Grease the top of
the rod in this area
Version: [###] Classification: Internal Owner: [Insert name]
7.
Guide Rod Main: Apply approximately

0.01 ml of grease to each of the six
peripheral parts of the arrow.
Guide Rod Front: The six peripheral

parts of the arrow.
After putting grease, apply it to the full

range of the dot-dash line and adjust it.
Circumferential grease application

range
Use a dedicated Cleaning Applicator to

spread the grease smoothly on the top
portion of the rod (cover about the top
third of the circumference of the rod.)
RICOH.
RICOH Type 1
170