Verifying Post-Installation Connectivity; Electrical And Environmental Specifications; Regulatory Information - Aruba AP-505H Installation Manual

Software Quick Start Guide.
Aruba access points are classified as radio transmission devices, and are subject to government regulations of
!
the host country. The network administrator(s) is/are responsible for ensuring that configuration and operation
of this equipment is in compliance with their country's regulations. For a complete list of approved channels in
your country, refer to the Aruba Downloadable Regulatory Table at
Default.htm.

Verifying Post-Installation Connectivity

The integrated LED on the access point can be used to verify that the access point is receiving power and
initializing successfully (see
further details on verifying post-installation network connectivity.

Electrical and Environmental Specifications

For additional specifications on this product, please refer to the product data sheet at
products/networking/access-points/.
Electrical
Ethernet:

Eth0: 100/1000/2500/5000 Base-T auto-sensing Ethernet RJ45 interface

Eth1: 100/1000/2500/5000 Base-T auto-sensing Ethernet RJ45 interface

IEEE 802.3u (100 Base-T). IEEE 802.3ab (1000 Base-T), IEEE 802.3bz (2500/5000 Base-T)

Power over Ethernet IEEE 802.3bt or 802.3at 56V DC (nominal)

Power:

48V DC power interface, support powering through AC-to-DC power adapter (AP-AC-48V36C)

Maximum power consumption (excluding USB): Refer to datasheet

If a power adapter other than the Aruba-approved adapter is used in the US or Canada, it should be NRTL listed,
with an output rated 48V DC, minimum 0.75A, marked "LPS" and "Class 2," and suitable for plugging into a
standard power receptacle in the US and Canada.
Environmental
Operating:

Temperature: 0°C to +40°C (+32°F to +122°F)

Humidity: 5% to 93% non-condensing

Storage and transport:

Temperature: -40°C to +70°C (-40°F to +158°F)

Humidity: 5% to 93% non-condensing

!
For indoor use only. The access point, AC adapter, external antennas, and all connected cables are not to be
installed outdoors. This stationary device is intended for stationary use in partly temperature controlled
weather-protected environments (class 3.2 per ETSI 300 019).

Regulatory Information

For the purpose of identification needed for regulatory compliance certifications, this product has been assigned
a unique regulatory model number (RMN). The regulatory model number can be found on the product
nameplate label, along with all required approval markings and information. When requesting compliance
information for this product, always refer to this regulatory model number. The regulatory model number is not
the marketing name or model number of the product.
AP-505H RMN: APINH505

Aruba Networks provides a multi-language document that contains country-specific restrictions and additional
safety and regulatory information for all Aruba access points. This document can be viewed or downloaded at
Aruba AP-505H Access Points
Table 1 and
| Installation Guide
www.arubanetworks.com/techdocs/DRT/
Table 2). Refer to the Access Point Software Quick Start Guide for
www.arubanetworks.com/
7