Safety Instructions - RACOM MG101 User Manual

1 Introduction
Thank you for purchasing MG101/102 Wireless Router from Racom. This chapter gives you an introduction to
MG101/102 Wireless Router. The following chapters describe the installation and the configuration.
1.1

Safety Instructions

The MG101/102 Wireless Router must be used in compliance with any and all applicable international and
national laws and in compliance with any special restrictions regulating the utilization of the communication
module in prescribed applications and environments.
To prevent possible injury to health and damage to appliances and to ensure that all the relevant provisions
have been complied with, use only the original accessories. Unauthorized modifications or utilization of ac-
cessories that have not been approved may result in the termination of the validity of the guarantee.
The MG101/102 Wireless Routers must not be opened. Only the replacement of the SIM card is permitted.
Voltage at all connectors of the communication module is limited to SELV (Safety Extra Low Voltage) and
must not be exceeded.
For use with certified (CSA or equivalent) power supply, which must have a limited and SELV circuit output.
The MG101/102 is designed for indoor use only. Do not expose the communication module to extreme am-
bient conditions. Protect the communication module against dust, moisture and high temperature.
We remind the users of the duty to observe the restrictions concerning the utilization of radio devices at pet-
rol stations, in chemical plants or in the course of blasting works in which explosives are used. Switch off the
communication module when traveling by plane.
When using the communication module in close proximity of personal medical devices, such as cardiac
pacemakers or hearing aids, you must proceed with heightened caution.
If it is in the proximity of TV sets, radio receivers and personal computers, MG101/102 Wireless Router may
cause interference.
It is recommended that you should create an approximate copy or backup of all the important settings that
are stored in the memory of the device.
You must not work at the antenna installation during a lightning.
Always keep a distance bigger than 40cm from the antenna in order to reduce your exposure to electromag-
netic fields below the legal limits. This distance applies to Lambda/4 and Lambda/2 antennas. Bigger dis-
tances apply for antennas with higher gain.
Adhere to the instructions documented in this user's manual.
User manual
GPRS/EDGE/UMTS routers MG101, MG102
3. Jul 2009
7 / 107