Responses - RACOM MG101 User Manual

4.3.2

Responses

HTTP Request
All HTTP Service Interface Com-
mands
All HTTP Service Interface Com-
mands
GET /cli.php?status,[parameters]
GET /cli.php?get,[parameters]
GET /cli.php?set,[parameters]
GET /cli.php?sw-
update,path=<value>
GET /cli.php?reboot
GET
/login.php?usr=<user>,pwd=<pass
word>
GET /logout.php
GET
/download.php?file=<fileName>
POST /upload.php
User manual
GPRS/EDGE/UMTS routers MG101, MG102
3. Jul 2009
Responses (String)
0: device busy
0: login required
<status>
<parameterValue>
0: set failed
1: set ok
1: sw-update started
from <path>
0: maximum length of
path is 26 characters
0: syntax error
1: reboot initiated
1: already logged in
1: already logged in but
supplied credentials do
not match
1: login ok
0: login failed
1: logout ok
1: already logged out
0: download <fileName>
failed
1: upload ok, files re-
placed, reconfiguration
started
1: upload ok, files re-
placed
0: upload failed: <error-
Message>
Description
The MG101/102 is busy. Resend the re-
quest later.
This command requires authentication.
Please use login.php first
A single or multiline string with the re-
quested status information
The value of the requested configuration
parameter
HTTP transfer is ok, but changing the
configuration parameter failed.
Software update started. Afterwards re-
quest the Software version with
cli.php?status to verifiy whether it was
successful or nor not
Wrong syntax after in sw-update pa-
rameters
A restart has been initated
Already logged in but supplied credentials
do not match
Logged in successfully
Login failed
Logout OK
You were not logged in
Download failed
Upload ok, the provided files (e.g.
OpenVPN certificates) were updated, the
user-config.cfg will be applied
No user-config.cfg provided but other files
were updated (e.g. OpenVPN certificates)
The upload failed
100 / 107