Moxa Technologies NPort 6600 Series Quick Installation Manual

NPort 6600 Series
Quick Installation Guide
Third Edition, June 2008
1. Overview
The NPort 6600 series of serial device servers includes 8-port, 16-port,
and 32-port models for connecting larger numbers of serial devices to
Ethernet. Some applications now also require better security when
transmitting data through a network. The NPort 6600 series of device
servers use DES, 3DES, and AES data encryption to provide secure
network communication.
2. Package Checklist
Before Installing your NPort 6600 series secure device server, verify that
the package contains the following items:
1 NPort 6600 series serial device server
Document and Software CD
Quick Installation Guide
Power Cord (for AC models only)
2 rack-mount ears
CBL-RJ45F9-150: RJ45 to female DB9 cable
Product Warranty Statement
Optional Accessories
DK-35A: 35 mm DIN-Rail Mounting Kit
DIN-Rail Power Supply
NM-TX01: Network module with one 10/100BaseTX Ethernet port
(RJ45 connector; supports cascade redundancy and RSTP/STP)
NM-FX01-S-SC: Network module with one 100BaseFX single mode
fiber port (SC connector; supports cascade redundancy and
RSTP/STP)
NM-FX02-S-SC: Network module with two 100BaseFX single mode
fiber ports (SC connectors; supports cascade redundancy and
RSTP/STP)
NM-FX01-M-SC: Network module with one 100BaseFX multi mode
fiber port (SC connector; supports cascade redundancy and
RSTP/STP)
NM-FX02-M-SC: Network module two 100BaseFX multi mode fiber
ports (SC connectors; supports cascade redundancy and RSTP/STP)
NM-GPRS/GSM: GPRS/GSM modem module
NM-Modem: One PSTN modem port with RJ11 connector
NOTE: Please notify your sales representative if any of the above items is
missing or damaged.
P/N: 1802066500012
— 1 —
3. Hardware Introduction
Rear Views
Network Module
Serial Ports Console LAN
Top View
Front Views
32
/
/
17 18 19 20 21 22
8
LCM Display LED Indicators
LED Indicators Push Buttons Reset Button
Optional Network Modules
Fiber Ethernet GPRS/GSM
RJ45 Ethernet
Reset button
Press the Reset button continuously for 5 sec to load factory defaults: Use
a pointed object to press the reset button. Release the button after the
Ready LED stops blinking.
Adjustable pull high/low resistor for RS-485 (150 KΩ or 1 KΩ)
The NPort 6650 has 3 DIP Switches associated with each serial port for
configuring the pull high/low resistors for RS-485 applications. The
switches are located in a recess on the bottom of the NPort 6650. To
access the switches, first remove the panel covering the recess.
1
SW
Pull High Pull Low Terminator
DIP-Switches
ON 1 KΩ
OFF 150 KΩ 150 KΩ
NOTE: For RS-232 applications, all DIP Switches for the port should be
set to the OFF position.
Rack Mounting
Use four screws to attach the NPort 6610/6650 to a standard rack
— 2 —
AC Power
DOUT Input
LED Indicators
Name
PWR
48 VDC
Power
Input
Ready
23 24 25 26 27 28 29 30 31 32
Link
SD Connector
(internal)
P1-P16 Tx
Modem
NM-GPRS/GSM NM-Modem
GSM
GPRS
DCD TxD RxD
LINE
P1-P16 Rx
FX
P1-P16
in-use
2 3
LEDs
1 KΩ 120 KΩ
Alarm
---
Module
GSM
GPRS
GPRS/GSM
Signal Strength
32
/
/
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
Color Function
Red Power is being supplied to the power input.
Power is on and the NPort
Steady on:
6600 series is booting up.
IP conflict, DHCP or BOOTP
server not responding, or relay
Red output. Check relay output
Blinking: first. If still blinking, then
there is an IP conflict, or the
DHCP or BOOTP server did
not respond properly.
Power is on and the NPort
Steady on: 6600 series is functioning
normally.
Green
The device server has been
Blinking: located by the Administrator's
Locator function.
Power is off, or power error condition
Off
exists.
Orange 10 Mbps Ethernet connection.
Green 100 Mbps Ethernet connection.
Ethernet cable is disconnected, or has a
Off
short.
Green Serial port is transmitting data.
No data is being transmitted through the
Off
serial port
Orange Serial port is receiving data..
No data is being received through the serial
Off
port.
Ethernet fiber connection, but
Steady on:
port is idle.
Orange
Fiber port is transmitting or
Blinking:
receiving data.
Serial port is opened by server side
Green
software.
Serial port is not opened by server side
Off
software.
Red The relay Dout is open (exception)
Off The relay Dout is Shorted (normal)
Green Network module is plugged in and detected
Off No module present
Green GSM Connection
Orange GPRS Connection
More LEDs indicates better signal; 4 LEDs
Green
indicates maximum signal strength.
— 3 —