Moxa Technologies NPort 6150 Series Quick Installation Manual

NPort 6150/6250 Series
Quick Installation Guide
Seventh Edition, August 2015
Overview
The NPort 6150/6250 series secure serial device servers provide
reliable serial-to-Ethernet connectivity for a wide range of serial
devices. The NPort 6150/6250 support TCP Server, TCP Client,
UDP, and Pair-Connection operation modes to ensure the
compatibility of network software. In addition, the NPort
6150/6250 also support Secure TCP Server, Secure TCP Client,
Secure Pair-Connection, and Secure Real COM modes for security
critical applications such as banking, telecom, access control, and
remote site management.
Package Checklist
Before installing a NPort 6150/6250 secure device server, verify
that the package contains the following items:
• 1 NPort 6150 or NPort 6250
• Power adapter (does not apply to -T models)
• 2 wallmount ears
• Documentation and software CD
• Quick installation guide (this guide)
• Warranty card
Optional Accessories
• DK-35A: DIN-rail mounting kit (35 mm)
• DIN-rail power supply
• CBL-RJ45M9-150: 8-pin RJ45 to male DB9 cable
• CBL-RJ45M25-150: 8-pin RJ45 to male DB25 cable
NOTE: Please notify your sales representative if any of the above
items are missing or damaged.
P/N: 1802061500014
– 1 –
*1802061500014*
Hardware Introduction
NPort 6150
NPort 6250
– 2 –
Reset Button—Press the Reset Button continuously for 5 sec to
load factory defaults. Use a pointed object, such as a straightened
paper clip or toothpick, to press the reset button. This will cause
the Ready LED to blink on and off. The factory defaults will be
loaded once the Ready LED stops blinking (after about 5 seconds).
At this point, you should release the reset button.
LED Indicators
LED Name LED Color LED Function
PWR Red Power is being supplied to the power input.
Steady on Power is on and the NPort is
booting up.
Blinking Indicates an IP conflict, or, the
DHCP or BOOTP server did not
respond properly or a relay
output occurred. Check the
Red
relay output first. If after
resolving the relay output the
RDY LED is still blinking, then
Ready there is an IP conflict, or the
DHCP or BOOTP server did not
respond properly.
Steady on Power is on and the NPort is
functioning normally.
Green Blinking The device server has been
located by the Administrator's
Location function.
Power is off, or power error condition
Off
exists.
Orange 10 Mbps Ethernet connection
Green 100 Mbps Ethernet connection
Link
Ethernet cable is disconnected, or has a
Off
short.
Orange Serial port is receiving data.
Green Serial port is transmitting data.
P1, P2
No data is being transmitted or received
Off
through the serial port.
Serial port was opened by server side
Green
P1, P2 software.
in-use LED
Serial port has not been opened by server
Off
side software.
– 3 –